View Full Version : Overheating problem....
Mr.Clean
09-06-2008, 05:35 PM
-fixed-
Race_Breed_2.0
09-06-2008, 05:40 PM
Does any coolant leak from the pump? It should if the pump is bad it will drain
weap hole.
nismojunkie
09-06-2008, 05:43 PM
the waterpump would wobble the shaft.
if it was going bad.
spoolie
09-06-2008, 05:48 PM
ive had several honda's with blown hg's with good compression...
daves sr engine had good compression with a blown hg.
Mr.Clean
09-06-2008, 05:50 PM
Does any coolant leak from the pump? It should if the pump is bad it will drain
weap hole.
I cant see any coolant around the pump but it is sort of in a tight spot, where is the weep hole? its a b16 motor btw
Race_Breed_2.0
09-06-2008, 05:56 PM
it should be around the pump usually around the bottom or the side pr the pump near
the shaft, take it up the road and then let it almost over heat and bring it home cut it off and see if it drains.
blackbelt
10-03-2008, 08:34 AM
You could have an air locked line. Try to bleed the coolant sytem.
tripleJs15
10-03-2008, 08:39 AM
You could have an air locked line. Try to bleed the coolant sytem.
you have a little irratic/fluctuating idle with air in the system.....
B18Hybridhatch
10-03-2008, 08:48 AM
My y8 did the same thing when i drove to florida, got down there started overheating. I did a compression test everything was fine. started to drive it back, it would overheat and push all the coolant out. got back pulled the head off and it was the gasket between the #2 and #3 cylinder
tripleJs15
10-03-2008, 08:55 AM
Just a thought maybe its florida ??????
No but like spoolie said even with good compression you can have a blown gasket
B18Hybridhatch
10-03-2008, 09:14 AM
No thats not why, i was fall it wasnt hot out at all. it was cuz i drove 80 all the was down there for 12 hours
tripleJs15
10-03-2008, 09:23 AM
i was joking....
vBulletin® v3.8.6, Copyright ©2000-2012, Jelsoft Enterprises Ltd.