Tennessee Car Forums at TennSpeed banner

92 Civic Si Turbo

2K views 3 replies 4 participants last post by  Scionide 
#1 ·
Posthing this for a friend on S2ki
I'm selling my 92 Civic Si Hatchback. This has been my Daily since August, The car is a blast to drive. I'm selling the car to move to the next project. I'm asking 7500$ OBO. I couldn't replicate the drivetrain in another Civic for that amount.

PM or text @ 615 393 one nine nine nine.

The Good:

I'm the 4th owner, the only ownerI don't knnow was the 1st.
I did the motor swap wiring for the B18C in 2001 for owner #3, I replaced the sunroof rails for owner #2 in 2000.
Southern car no rust. I'm sure that I'm forgetting a few parts on the car



The car made 310WHP on a Mustang Chassis dyno @17psi with a Catalytic Convertor.


JDM B18C1
ITR LSD Transmission with LSD. New Synchrotech 3rd gear and carbon coated synchros. Does not grind upshifting or downshifting.
GSR double bend shift lever, energy suspension bushings.
ACT HDSS Clutch replaced 3K miles ago (street disc)
New Hasport Urethane mount inserts
DSS Street Axles
New LF wheel bearing
Endyn Catch can
Ferrea Valves, springs and retainers
Ported B18C1 Head
Knife edged and polished stock crank
Eagle Rods
Custom 10.5:1 Wiseco pistons
Stock GSR cams
Walbro 255lph fuel pump
FAL Electric Fan
2" core Aluminum Radiator
Snow Performance Methanol injection (Not hooked up)
Go-Autowerks ramhorn manifold
Go-Autowerks intercooler
Custom built downpipe and chare pipes
TiAL 38mm Wastegate
TiAL BOV
P28 Hondata S300V3 ECU with bluetooth and PWM boost control output.
RC650cc Injectors
PLX Wideband AF sensor and gauge
Full 3" Exhaust from downpipe back
Thermal Reasearch Stainless turbo exhaust
Garrett GT3071R water cooled ball bearing turbo
Dynomax 3" bulle Catalyst (Passed Rutherford Co Emmisions)
Fastbrakes 11" front rotors and Wilwood dynalite 4 piston calipers
New Master Cylinder and proportioning valve
EBC Brake pads, stainless lines
H&R coilovers
Nuespeed 4 point front STB
Progress rear sway bar
Skunk 2 front upper conrol arms
Ingalls rear toe arms
Lower control arm bushings have been replaced
Custom rear tiebar with sway bar mounts
Coverted to Manual steering with a manual rack and pinion
JDM ITR non-airbag steering wheel (mint)
New OEM floor mats and mudguards
Armrest console (Si's did't come with)
AC has been removed (#turbo) AC parts ae included
Kosei K1 TS 15x7 wheels with Kumho Ecsta XS tires
Custom Louvered OEM Steel hood
3M Vinyl wrapped rood
Repainted R81P Milano Red by Jonathan Goolsby


The Bad:

Insurance "totalled" the car after a front end collision that required a hood and core support.
The Vehicle was professionally repaired with a new core support, bumper and hood.
I'm an ASE Master tech, this car is straight and was repaired correctly.


The Pics:






 
#4 ·
Looks like a quality car, definitely not my cup of tea, but looks good
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top