Tennessee Car Forums at TennSpeed banner
1 - 9 of 9 Posts

·
Registered
Joined
·
764 Posts
Discussion Starter · #1 ·
Hey guy I just pick up a engine stand from harbor feight.I am going to put a dohc ZC 0BD0 on it to build it for boost. So what size bolts do i need to put the motor on the stand?? Thanks guy
 

·
Registered
Joined
·
764 Posts
Discussion Starter · #3 ·
Can't use the transmission bolts because this motor is a spare motor i had laying around. i just did not want to make 100 times to homedepot to find the right bolts
 

·
Internet Warrior
Joined
·
5,476 Posts
3: m10 x 1.25 x something between 55-70mm.
1: anysize bolt n nut that will fit thru hole for bracket where the lower back bracket goes...
 

·
Install Tech
Joined
·
3,780 Posts
all you have to do is come by and take a look loser. and when did you decide to boost your car. and which of your 3 cars are you boosting??? please say its you tl... please
 

·
Registered
Joined
·
764 Posts
Discussion Starter · #9 ·
rudedawwg said:
all you have to do is come by and take a look loser. and when did you decide to boost your car. and which of your 3 cars are you boosting??? please say its you tl... please
yea I can't afford the turbo for the tl plus i would put a comptech supercharger on it. i am going to start working on disassembling the zc in the barn so i can get closer to sleeving the block.
 
1 - 9 of 9 Posts
Top