Tennessee Car Forums at TennSpeed banner
1 - 1 of 1 Posts

· Registered
212 Posts
Discussion Starter · #1 ·
I have a couple questions about what head gasket to use for this setup...

Here's the nitty gritty...

I bored the bottom end to 87.5mm and now i'm wondering what head gasket to use. Do i stick with the oem 87mm or the next size up which would be 88mm??? Thanks for any help
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.